First Mash run
- This topic has 3 replies, 2 voices, and was last updated 9 years, 2 months ago by .
-
Posts
-
-
I am just finishing with fermenting my first whiskey mash…I have a 1 gallon still and 6 gal of mash.Being the first run in my still, should I run it through one time as a spirit run and age the product? Or run it through twice ? Any recommendations ?
-
Make sure you do a good cleaning run in the still if you have not.
If I were in your shoes I would do 6 stripping runs- save everything from those runs and do 1 final spirit run.
You can do 6 stripping runs in an afternoon if you have the time- or split it up into two sessions.
Fill the still- crank the heat until you have a decent stream and collect down to 10-20%-
then dump the still and fill it back up and run it again- until all of the mash is done.the next session add all of the “low wines” (everything collected from the stripping runs) and do a slow spirit run.
I think that would give you the best final product and maximize time and effort.
-
-
Always go by feel and taste-
write down the notes in your notebook- if you run the same batch again it should be similar. I always take notes and have a few of my recipes dialed in- I always go by feel and taste but my temps are usually pretty spot on
-